 Designed for use on resilient
tile or other porous surfaces as a base coat for StaticSmart Finish. Can
also be used alone as combination sealer/finish for hard surfaces such
as coated or bare concrete, terrazzo, ceramic tile or stone.
Covers approximately1500-2000 square feet per gallon depending on the
porosity of the surface.
Application and Maintenance
For best results, apply StaticSmart Seal to surfaces that are 60º
F or warmer and in relative humidity conditions of between 40-65%. Remove
old finish or sealer with StaticSmart Remover. Vacuum stripping solution
and rinse the floor with clean water to remove any dissolved finish residue.
When used as a base coat for StaticSmart Finish, one or two coats are
recommended depending on the porosity of the surface. When used as a sealer/finish
on hard surfaces, two or three coats will provide the optimum gloss and
durability. Apply thin even coats, allowing approximately 30-45 minutes
drying time between coats. Allow two hours between the last coat of Seal
and the first coat of Finish.
When used as a sealer/finish, recoat in the following manner: Vacuum
the floor to remove any loose dirt or dust. Wash the floor with StaticSmart
Clean to remove dirt and soil. Apply thin even coats, allowing approximately
30 minutes for Seal to dry before resuming of foot traffic. Floor surfaces
should be swept with an untreated mop daily to remove abrasive loose dirt
and sand. Floors should be damp mopped with StaticSmart Clean regularly,
to remove soil, salt, and film deposits which can degrade the coating's
conductive properties and gloss. For optimum results do not apply
during humid conditions and do not dry-buff or burnish. |
