Floor Maintenance Products for ESD Floors

This innovative spray buff is a companion product for StatCare Finish. An integral component of a conductive maintenance program, StatCare Buff is designed to extend the static dissipative qualities of StatCare Finish, as well as restore the gloss and enhance the appearance of conductive flooring surfaces.

• Easy to Use
• Extends Life of Static Dissipative Finishes
• Extends Periods between Stripping and Recoating
• Saves Time and Money 

Application
Remove loose dirt and soil by sweeping or vacuuming. For best results, first damp mop area with StatCare Clean, our conductive cleaner. A good quality neutral cleaner can also be used to damp mop with minimum adverse effect to the finish properties. Using a soft or medium pad, spray Buff ahead of the buffing machine, working small areas at a time. StatCare Buff can also be diluted 32 ounces per gallon of water (1:4) for use as a mop-on restorer. Dilute the StatCare Buff in a mop bucket with cold water. Damp mop the area using a lint free cotton or combination cotton and synthetic mop. Allow the floor to dry thoroughly then burnish with a soft pad. Wash and rinse buffing pads after each application.

Regular cleaner and detergent compounds destroy the static dissipating properties of highly specialized conductive floor finishes like StatCare Finish, rendering their static control properties ineffective.

StatCare Clean removes dirt and soil while maintaining or increasing the conductivity of StatCare Finish, StatCare Buff or StatCare Seal. StatCare Clean is equally effective on vinyl, vinyl-asbestos, rubber, linoleum, ceramic and concrete surfaces. 

Application and Maintenance
Floor surfaces should be swept or vacuumed prior to washing to remove loose dirt and soil. For use in daily or frequent mopping, use a diluted solution of 8-10 ounces of StatCare Clean per gallon of warm water. Mop the floor lightly and allow it to dry. Do not rinse. For heavier soil conditions, sweep or vacuum the floor to remove soil or dirt. Dilute 12 –16 ounces of Clean per gallon of warm water and use as a mopping solution. After cleaning, the floor can be spray-buffed with StatCare Buff or recoated with StatCare Finish. Do not use plain water or regular all-purpose cleaners for maintaining conductive finishes.