StaticSmart offers our StatCare line of ESD Floor Care Products to help you maintain your high performance ESD floors.
 Our most effective stripper, Remover rapidly dissolves multiple layers of floor finish.
Application and Maintenance
Dilute 32 ounces of Remover for routine stripping, 42 ounces for medium buildup or 128 ounces for heavy buildup per gallon of warm water. Apply stripping solution with a mop. Let stand for five minutes. Remove the dissolved finish and solution with a wet vacuum. Any residual dissolved floor finish that remains after vacuuming should be removed by light rinsing or damp mopping. Allow floor to dry thoroughly before applying any other finish. Remover is not recommended for use on Asphalt Tile or older Linoleum Tiles, as it may remove the dye, particularly from dark-colored tiles. |
StatCare Remover Specs -
  |
StatCare Remover MSDS -
|
|
A new state-of-the-art floor maintenance finish with inherent static dissipating properties. The unique static dissipating ingredient is actively linked to the chemical structure of the polymer system, preventing washout or leaching of the static dissipative properties.
|
 Application
For best results, apply StatCare Finish to surfaces that are at least 60º F or warmer and in conditions where relative humidity is between 40-65%. Remove old finish or wax with StatCare Remover. Follow directions on stripper label. For optimum appearance and gloss on initial application, use three to five coats of finish. No more than three coats should be applied in an eight hour period. Apply thin coats. Depending upon humidity, allow approximately 30-45 minutes drying time between coats.
Maintenance
Vacuum the floor to remove any loose dirt or dust. Wash the floor with StatCare Clean to remove dirt and soil. Apply thin, even coats, allowing approximately 30 minutes to dry before resumption of foot traffic. The frequency of stripping and refinishing will vary depending on the environmental conditions with a particular facility. However, field experience indicates that monthly refinishing generally provides optimal results. |
StatCare Finish Specs -
|
StatCare Finish MSDS -
|
| |
| A routine maintenance program provides the most satisfactory gloss retention and wear characteristics of any floor coating. Floor surfaces should be swept with an untreated mop daily to remove abrasive loose dirt and sand. Floors should be damp mopped with StatCare Clean regularly, as needed, to remove soil, salt and film deposits which can degrade the coating's conductive properties and gloss. Spray buffing with StatCare Buff is recommended to reduce the necessity of recoating and maintain optimal appearance and static dissipative qualities. |
back to top 
print this page
